C) Disabling The Fixed Soldering Tip Temperature - TOOLCRAFT ST-100HF Bedienungsanleitung

c) Disabling the fixed soldering tip temperature

As described in section 10. b), if you have set a fixed soldering tip temperature, the soldering station will automatically
heat the soldering iron to the preset temperature when it is switched on. The temperature cannot be changed using
the control buttons (2) or the temperature control dial (7).
To disable this function and set the temperature using the control buttons (2) or the temperature control dial (7), follow
the steps below:
• Enable settings mode as described in section 10. a).
• Press button "1" when the main menu is displayed.
• "SET TEMP." will appear briefly on the display.
"ENT.PASS 000" will be displayed.
• Use the three control buttons (2) to enter the password.
"1" = Decrease value
"2" = Choose input position
"3" = Increase value
• Hold down button "2" to confirm your entry. The password will flash three times and "SET TEMP 000" will be
displayed.
• Leave the temperature setting at "000".
Saving "000" disables the fixed soldering tip temperature. Setting another temperature ("050"...."480") only
changes the fixed temperature. The new setting takes effect the next time you restart the soldering station.
Always set the temperature to "000" if you wish to disable the fixed temperature function.
• Hold down button "2". "000" will flash three times and "SET TEMP SUCCESS" will be displayed (= temperature
was successfully set).
• After a few seconds the display will revert to the main menu (see screenshot in section 10. a).
• Switch the soldering station off using the on/off switch (1).
• After you switch the soldering station back on, you can use the control buttons (2) or the temperature control dial
(7) to manually change the soldering tip temperature.
If you wish to program a fixed soldering tip temperature, follow the steps in section 10. b).
41