Recharging The Battery; Checking The Battery Charge Level; Operation; Direction Switch - Parkside RAPIDFIRE Originalbetriebsanleitung

• Charge the battery before the first
time of use. Do not briefly charge
the battery several time in a row.
• Recharge the battery when you no-
tice that the appliance is becoming
slower.
• Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
• The warranty excludes all defects
caused by improper handling.

Recharging the battery

1. Connect the charger plug to the
charging socket (
vice.
2. Plug the battery charger (
into a mains outlet.
3. When the battery is fully re-
charged unplug the battery
charger (
Red LED lights up
Green LEDs light up
Checking the battery charge
level
The battery's charge level is indicated by
the charge state indicator (
The state of charge of the battery is displa-
yed by illuminating the appropriate LED
lights. In order to activate the display, the
on/off switch ( 10) must be pressed.
Green LED lights up
Battery fully charged
Red LED lights up
Battery needs to be charged
7) of the de-
12)
12) from the mains.
Battery charging
Battery fully
charged
6).

Operation

1. Direction switch

You can toggle between right and left ro-
tation by pushing the direction of rotation
switch ( 9).
If you move the direction switch (
the middle position, the device is secured
against being switched on.
The direction changed may
only be performed in stand-
still mode!

2. Bit selection from the

bit changeable drum
Push the slide of the interchangeable cord-
less screwdriver (
B
Turn the bit changeable drum to the left or
right until the desired bit is located on top
and is in line with the bit holder (
bit changeable drum engages audibly.
Push the slide of the interchangeable cord-
less screwdriver (
B
Only grab the side of the
slide of the interchangeable
cordless screwdriver.
Caution, risk of injury caused
by pinching!
The selected bit is automatically fixed in
the bit holder ( 4).

3. Use extension bit holder

Remove the current bit (
holder ( 4).
GB
9) to
5) forward.
4). The
5) to the back.
3) from the bit
IE
11