Charging The Battery; Recharging The Battery; Checking The Battery Charge Level; Starting Up - Parkside RAPIDFIRE 2.0 Originalbetriebsanleitung

Charging the battery

Do not expose the battery to
extreme conditions such as
heat or impact. Risk of injury
from escaping electrolytic so-
lution! After eye/skin contact,
rinse the affected areas with
water or a neutraliser and
consult a doctor.
Charge the battery in a dry room
only.
There is a risk of injury due to elec-
tric shock.
Only use the original charger from
the package to charge the battery.
• The device may only be powered
with SELV (Safety Extra Low Vol-
tage) as marked on the device.
• Charge the battery before the first
time of use.
• Always take heed of the applicable
safety instructions as well as the en-
vironmental protection regulations
and information.
• The warranty excludes all defects
caused by improper handling.

Recharging the battery

1. Connect the charger plug to the
charging socket (
vice.
2. Plug the battery charger (
into a mains outlet.
3. When the battery is fully re-
charged unplug the battery
charger (
6) of the de-
11)
11) from the mains.
GB
The charge state indicator (
Red LED lights up
Green LEDs light up
Checking the battery charge
level
The battery's charge level is indicated by
the charge state indicator (
The state of charge of the battery is displa-
yed by illuminating the appropriate LED
lights. In order to activate the display, the
on/off switch ( 9) must be pressed.
Green LED lights up
Battery fully charged
Red LED lights up
Battery needs to be charged

Starting up

Before the starting up must
the transport safety (
removed.
Open the transport safety (
ve the transport safety of the bit holder
( 3).

Operation

Switching on/off

Press the on/off switch (
vice. To turn it off, release the on-off button.
If you move the direction switch (
the middle position, the device is secured
against being switched on.
IE NI CY
5) lights up.
Battery charging
Battery fully
charged
5).
1)
1) and remo-
9) to start the de-
8) to
11