Configuring Tubular Motors; Loading Factory Settings During The Commissioning Process - RADEMACHER RolloSun RSFM 10/16 Einbau- Und Gebrauchsanleitung

Configuring tubular motors
The tubular motors can be individually configured with the help of a cord circuit setting
unit (20).
The following configurations are possible.
◆ Reload the factory settings.
Loading factory settings during the commissioning process
Automatic configuration of the upper end point is available again once the factory settings
have been loaded.
NOTE
We recommend undertaking these settings with two persons.
IMPORTANT
The tubular motor may not be in operation.
1.
A.
2.
3.
4.
5.
Symbols and actions when connecting a cord circuit setting unit (20)
or
when connecting an external switch.
Switch off the mains power.
or
If a cord circuit setting unit (20) is being used, then the rocker switch must be positioned to the centre position.
OFF
+ B.
First press and hold the set button (7) on the tubular motor (9) and subsequently press and hold the SET button
on the cord circuit setting device (20) (possibly a second person carries this out).
or
SET
ON
Additionally switch on the mains power. Hold all buttons.
or
ON
After approx. 10 seconds the tubular motor acknowledges loading of the factory settings by briefly running up
10 s
and down.
Release the set button (7) on the tubular motor (9) and the SET button (or the external switch, if connected).
or
SET
Switch off the mains power again.
or
OFF
NOTE
Additional settings can be undertaken with the optionally available RT ConfigTool. Please
refer to the information on our Website www.rademacher.de.
Factory settings:
End points:
Fabric tensioning (reversing) after the
end point has been reached or switching
on / off after obstacle detection:
EN
No end points stored
activated
45