Electrical Connection Of The Tubular Motor (Fig. J ); Control With 1-Pole Switch (Closer) (Figure K ) - RADEMACHER RolloSun RSFM 10/16 Einbau- Und Gebrauchsanleitung

Electrical connection of the tubular motor (Fig. j )
10
(a)
(b)
(c)
Control with 1-pole switch (closer) (Figure k )
The radio tubular motor can be controlled locally by means of connecting a 1-pole switch
(closer) to the "external switch" conductor.
In doing so, the switching sequence is as follows:
Retract/stop/extend/stop, and so on.
11
(a)
(b)
(c)
(d)
(e) (f) (g) (h) (i)
(d)
(e) (f) (g) (h) (i)
Legend
(a) = set button (7)
(b/d) = socket box
(c) =
Mains 230 V/50 Hz
Pin assignment
(e) = PE green/yellow
(f) = N
blue
(g) = L black
(h) = external switch
white (not used in this example)
(i) = Antenna violet
IMPORTANT
◆ If the "external switch" (h) lead is not used, then it must be connected to the
neutral conductor (f), (see fig. j).
Legend
(a). = set button (7)
(b) = 1-pole switch
(c) =
Mains 230 V/50 Hz
(d). = Socket box
Pin assignment
(e). = PE
green/yellow
(f). = N blue
(g). = L
black
(h). = external switch white *
(i). = Antenna
violet
* maximum cable length between tubular motor and external switch = 10 m
IMPORTANT
◆ If the "external switch" (h) lead is not used, then it must be connected to the
neutral conductor (f) (see fig. j).
EN
39