Configuring Tubular Motors; Loading Factory Settings During The Commissioning Process - RADEMACHER 2740 06 65 Original Montageanleitung Und Betriebsanleitung

Configuring tubular motors

The tubular motors can be individually configured with the help of a cord circuit setting
unit (22).
The following configurations are possible.
◆ Reload the factory settings.

Loading factory settings during the commissioning process

Automatic end point configuration is available again once the factory settings have
been loaded.
NOTE
We recommend undertaking these settings with two persons.
IMPORTANT
The tubular motor must previously have been disconnected from the
power.
1.
2. A.
3.
4.
5.
50
Symbols and actions when connecting a cord circuit setting unit (22)
or
when connecting an external switch.
Switch off the mains power.
or
If a cord circuit setting unit (22) is being used, then the rocker switch must be positioned to the centre position.
OFF
+ B. First press and hold the set button (11) on the tubular motor and subsequently press and hold the SET button on
the cord circuit setting device (22) (possibly a second person carries this out).
or
SET
Additionally switch on the mains power. Hold all buttons.
or
ON
After approx. 10 seconds the tubular motor acknowledges loading of the factory settings by briefly running up
10 s
and down.
Release the set button (11) on the tubular motor and the SET button (or the external switch, if connected).
or
SET
Switch off the mains power again.
or
OFF
NOTE
Additional settings can be undertaken with the optionally available RT ConfigTool. Please
refer to the information on our Website (www.rademacher.de).
Factory settings:
End points: No end points stored
Automatic adjustment of the end points: activated
Reversing after obstacle detection: activated
Reversing after blockage detection: activated
Shutter length compensation system: activated
EN