Control Unit For Single System (Up To Model Year 12/09) - Kessel Aqualift F Duo Anleitung Für Einbau, Bedienung Und Wartung

8.2.6

Control unit for single system (up to model year 12/09)

Display elements (LEDs)
Normal mode
(for information
for the operator)
Problem
(for information for the
fitter, motor protection
switch also for the
operator)
Control elements
Manual - 0 - Auto
Alarm reset
Motor protection switch
The operating elements can be accessed once the transparent housing cover has been removed. The housing
cover may be removed for operational purposes, but it only makes sense for service work.
The protective rating given is reduced when the cover is removed (water-tightness). Before removal, it must be
checked whether there is a hazard through high humidity or splashwater. In this case, the control unit must be
switched voltage-free first. In case of doubt, a qualified electrician must always be consulted.
The current set at the motor protection switch must correspond with the rated current of the connected motor
Following operation, the housing cover must be sealed properly again to guarantee the protective rating
(water-tightness).
STANDARD CONTROL UNIT
operation
„Alarm" level
„On" level
„Off" level
Pump
Phase / rotary field
Motor protection
switch
Motor temperature
Running time / level
Sliding switch
Key
Switch
66/228
green Voltage supply OK
yellow Alarm level exceeded
yellow „On" level reached
yellow no function
green Pump output activated
red Permanently lit: Phase failure (has display priority)
Flashing:
red Motor protection switch has triggered
red Flashing:
red Permanently lit: Running time fault
Flashing:
Choice of operating mode
Reset / alarm signal sensor test
Reset of a level fault display
Reset of excess motor temperature
Triggered when pump has excess current
Rotary field fault
„Temperature A" (TF)
Level fault
saving - priority treatment
V 1.0