Installing The Control Unit; Electrical Connection - Kessel Aqualift F Basic Einbau- Und Betriebsanleitung

5.6

Installing the control unit

Select installation position taking the following into
account:
There is a safety socket in the direct vicinity of the con-
trol unit.
The connecting cable from the wastewater pump and
float switch can be installed correctly and routed to the
control unit.
The control unit can be fastened safely and suffi-
ciently.
Unscrew housing cover.
Fit all three fastening screws (drilling template included
in the scope of delivery). In doing so, ensure that the dis-
tance (A) between the screw heads and the fastening
surface is ca. 3 to 4 mm.
Hang the control unit on the three fastening screws and
press downwards gently. (1)
5.7

Electrical connection

DANGER
Danger through incorrectly dimensioned connection cables.
The system is intended exclusively for operation with the connection pipes provided (or equivalent). In case of
doubt, contact the manufacturer/supplier.
Lay the connection cable securely (e.g. conduit pipe)
from the system tank to the control unit. Ensure that there
is adequate cable length for the maintenance of the elec-
trical components.
Attach ferrules (length 8 mm) to the cable ends.
Unscrew and remove housing cover.
Feed connection cable through suitable cable gland.
Fasten connection cable to the terminal strips in accor-
dance with connection diagram.
To do so, use a suitable screwdriver to hold down the
respective cable clamp against the spring pressure until
the cable end has been inserted.
Fasten strain relief for all connection cables - tightening
torque 0.5 Nm.
Fit battery connector onto the battery.
Route the battery cable such that the LEDs are not cov-
ered or trapped.
Fit the housing cover and fasten in place - screw tighten-
ing torque 1.2 Nm.
010-974 Lifting station/Installation and operating instructions 29 / 112