Gardens Best GB 1/38 BT Bedienungshinweise Seite 36

• Place the metal cutting blade (2) on the rider plate. Make sure that the cutting blade
is engaged and is positioned level and centred.
• Place the flange (b) on the cutting blade with the flat surface.
• Tighten the screw nut (c) by using the enclosed toothed lock washer counter-
clockwise with the help of the combination spanner.
• Remove the blocking bolt (a).
To remove the metal cutting blade, follow these instructions in the opposite sequence.
Attention! The diameter of the cutting blade borehole must correspond precisely with
the diameter on the rider plate.
Fuel and lubrication
Fuel
• Use unleaded gasoline mixed with 40:1 two-stroke motor oil. This will result in an
optimal performance of the device. Warning! Never use just pure gasoline for your
device. This leads to permanent damage to the motor and will void any warranty for
this product. Never use a fuel mixture that has been stored for more than 90 days.
Warning! Only use first-class oil for two-stroke motors, mixed in a 40:1 ratio. Do not use
two-stroke motor oil with a recommended mixing ratio of 100:1. If insufficient lubrication
should turn out to be the cause for any motor damage, then the warranty is void.
Gasoline and oil mixture 40:1
• First, fill the oil into a container approved for fuel and then add the gasoline so that it
can be mixed with the oil. Shake the container to ensure a good mix.
Warning! Lacking lubrication will result in the warranty being voided. Gasoline and oil
must be mixed with a ratio of 40:1.
1130223-1130224 BDA GB 1/38 BT - 1/44-23 MS.indd 35
c
b
2
a
35
13.09.12 15:48