Herunterladen Inhalt Inhalt Diese Seite drucken

Grinding With The Dry Grinding Disc; Grinding With The Wet Grinding Disc; Change Grinding Disc; Change Dry Grinding Disc - Parkside PNTS 250 A1 Originalbetriebsanleitung

Nass-/trockenschleifer
Vorschau ausblenden Andere Handbücher für PNTS 250 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

G B
I E
N I
Grinding with the dry
grinding disc
Place the workpiece on the workpiece
support (
6) and slowly bring it to its
desired angle on the dry grinding disc
(
5).
to side in order to achieve an optimal
grinding disc is worn uniformly. Oc-
casionally, allow the workpiece to cool
down.
Fold the spark protection device (
downwards while grinding in order to
avoid injury from sparks.
Grinding with the wet
grinding disc
Check the water level in the water
be submerged in water up to the water
level mark
13).
Stand in front of the wet grinding disc
(
1).
Hold the workpiece with both hands
and lower it slowly onto the wet grind-
ing disc.
on the teeth of the water tank (

Change grinding disc

Information on replacement:
• Never operate the device without
protective equipment.
• Ensure that the rotation speed
stated on the grinding disc is the
same or higher than the nominal
rotation speed of the device.
• Ensure that the grinding disc
1 4
1) is to
on the water tank (
dimensions match those of the
device.
(sound test: an undamaged grind-
ing disc hanging freely on a
string will result in a clear sound
if it is tapped with a plastic ham-
mer).
• Never re-drill a locating hole
which is too small to make it
larger.
• Never use separate bushings or
adapters in order to make grind-
2)
ing discs whose hole is too large
• Do not use any saw blades.
must be made of elastic materials
e.g., rubber, soft cardboard etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Switch the device off and remove
the mains plug.
Allow the device to cool down.
Wear protective gloves when
13).
changing the grinding discs in or-
der to avoid cutting damages.

Change dry grinding disc:

1
move the dry grinding disc cover
(
(25).
2. Unscrew the grinding disc
nut (22) with a screw wrench
(SW19) and hold against the
4) from the protective hood
-
-
-

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

275344

Inhaltsverzeichnis