Further Safety Instructions - Parkside PNTS 250 A1 Originalbetriebsanleitung

G B I E N I
before servicing and when changing
accessories disconnect tools from the
power supply.
Such preventive safety measures reduce
the risk of starting the power tool acci-
Remove adjusting keys and
•
wrenches. Form the habit of checking
to see that keys and adjusting wrenches
are removed from the tool before turn-
ing it on. A wrench or a key left at-
tached to a rotating part of the power
tool may result in personal injury.
Avoid unintentional starting.
•
plugging in.
Use outdoor extension leads.
•
When the tool is used outdoors, use
only extension cords intended for out-
door use and so marked.
Stay alert, watch what you are
•
doing and use common sense
when operating a power tool.
Do not use a power tool while you are
alcohol or medication. A moment of
inattention white operating power tools
may result in serious personal injury.
Check damaged parts.
•
power tool is maintained.
- Before further use of tool, it should be
carefully checked to determine that it
will operate properly and perform its
intended function.
- Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other condi-
tions that may affect its operation.
- A guard or other part that is dam-
aged should be properly repaired or
replaced by an authorized service
centre unless otherwise indicated in
this instruction manual.
1 0
- Have defective switches replaced by
an authorized service centre.
- Do not use the tool if the switch does
not turn it on and off.
Warning.
•
other than one recommended in this
instruction manual may present a risk of
personal injury.
Have your tool repaired by a
•
qualified person.
complies with the relevant safety rules.
Repairs should only be carried out by
parts, otherwise this may result in consid-
erable danger to the user.

Further Safety Instructions

• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured residual
current of not more than 30 mA.
• Keep the mains cable and extension
the event that it is damaged or severed,
immediately disconnect the plug from the
socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
nection line must always be executed
by the manufacturer of the electric tool
avoid any hazards.
• Only switch the device on once it is
• For your own safety only use accessories
and attachments which were stated in
the operating instructions or recommend-
• Only use grinding tools recommended
-