Assembly; Assemble/Set Workpiece Supports; Assemble/Adjust Spark Protection; Screw Device On To Workbench - Parkside PNTS 250 A1 Originalbetriebsanleitung

G B I E N I

Assembly

Caution! Risk of injury!
space in which to work, and that
you do not endanger other peo-
ple.
- Always fasten the device on to
the work surface with screws
thickness in order to maintain
control of the device.
- All covers and protective devices
must be assembled properly be-
fore commissioning.
- Disconnect the mains plug before
changing the setting on the de-
vice.
Assemble/set workpiece
supports
1. Screw the workpiece supports
(6) on to the device.
washer (15), toothed washer (14)
and star nut (7) supplied.
2. Set the workpiece support (6) of
the dry grinding disc with the star
grip nut (7) so that the distance
between the dry grinding disc
(5) and the workpiece support is
max. 2 mm.
Periodically readjust the workpiece
support in order to offset the wear
and tear of the grinding disc (dis-
tance max. 2 mm).
1 2
Assemble/adjust spark
protection
1. Screw the spark protection holder
2. Adjust the spark protection holder
1
Screw device on to work-
bench

Fill water into the water tank

1
(18) onto the protective hood
( 25). For this, use the ad-
justing screw (21) including the
and the nut (17).
(18) with the aid of the adjusting
screw (21) - the distance between
the dry grinding disc (
the spark protection holder (18)
must be max. 2 mm (see small
image).
Periodically readjust the spark pro-
tection in order to offset the wear
and tear of the grinding disc (dis-
2
Despite the spark protection, you
should always wear protective
glasses when working in order to
avoid eye injuries.
bench with 4 screws and nuts.
holes (9) on the base of the device.
sembly are not part of the scope of
delivery.
the drain opening of the water
tank (13).
2 1
5) and
-
-
11