Emergency Stop Switch; Saw Blade Height Adjustment; Adjustment Of The Saw Blade Tilt; Setting The Spindle Height - Holzmann K5 315Vf-2000 Originalbetriebsanleitung

ASSEMBLY
Set to turn on the selected mode with the selector switch B. Press the ˝ I˝ button to start the
engine. To stop the machine, press the ˝O˝ key
14.2.2

EMERGENCY STOP switch

Pressing the EMERGENCY STOP switch ˝C˝, the machine will stop immediately. To pull out the
turn to the right and tighten slightly.

14.2.3 Saw blade height adjustment

To adjust the height of the material of the saw blade, loosen the
screw knob˝ D˝ and turn the handwheel clockwise around the saw
blade upward lift. Rotate counter-clockwise to lower the saw blade.
D
With the screw button D, the adjusted height can be fixed

14.2.4 Adjustment of the saw blade tilt

WARNING: Perform the setup of the circular saw blade height and tilt by only with
the machine switched off.
The handwheel on the right front side is for adjusting the blade angle.

14.2.5 Setting the spindle height

WARNING: Perform the setup of the spindle height and tilt by only with the
machine switched off.
Install the handwheel from the right shaft adapter onto the shaft adapter onto the
threaded spindle on the left. By clockwise rotation, the spindle moves up.
Anticlockwise Down.
The setting can be read on the display below.
14.3

Planer

(A)
Set dressing on the adjusting screw
Setting the plane shaft cover so that between the cover and the
workpiece remains about 5 mm distance
A
Start the engine as described in 7.2.2
Press the workpiece with one hand against the jointer
Push the workpiece with the second hand slowly and evenly over the
planer
O˝
Off after crimp Planer with Stop button ˝
Before other activities to wait until planer stands still!
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 50
5-fach Kombination / combined 5-operation machine K5 315VF-2000