Settings; Swivel Table; Aligning The Saw Band / Tilt Adjustment - Holzmann HBS 230HQ Betriebsanleitung

16.2

Settings

16.2.1 Swivel table

 Loosen the lock with the quick-release lever.
 Swing the table to the angle adjustment knob
to the desired angle.
 Fix the table with the table locking handle in
front of the first section
 The desired angle is expediently to be
checked by test cuts
16.2.2

Aligning the saw band / tilt adjustment

If the bandsaw blade is not running in the center on the rollers, is corrected by adjusting the
inclination of the caster the position of the saw blade.
 Open the upper and lower rollers cover (Fig. A)
 Turn by hand slowly in the upper roller clockwise. The saw blade to run centered on the
rubber pads of the caster. If this is not the case, the inclination angle of the upper
Sägebandrolle must be corrected.
 Loosen the lock (Fig.B) using the rotary knob.
 Turn to control the roller by hand in a clockwise direction around the barrel of the saw band.
Note that the running direction of the saw blade from top to bottom. Correct the running of
the saw blade by turning the knob left or right.
 Now check the running of the saw band on the lower roller. It should lie in its entire width on
the rubber pad. Correct the run until the saw band on the upper Sägebandrolle running
centered.
After the adjustments fix again everything and close both covers
Upper cover
Upper cover
After the adjustment and before switching on, turn the upper band saw wheel by
hand a few turns to see whether the saw band runs from the rolls. If so, the band
saw wheel must be set again.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Fig. A
Angle adjustment knob
N O T E
HOLZBANDSÄGE / WOOD BANDSAW HBS 230HQ
OPERATION
Table locking handle
Tracking set knob
Fig. B
Seite 36