Changing Saw Blade; Gearbox; Cleaning; Disposal - Holzmann BS 712TOP Betriebsanleitung

15.2

Changing saw blade

Remove the saw blade protection cover by loosening and

removing all screws.
Loosen the saw band with the hand wheel entirely.

Now remove cautiously the old saw band. Use cutting

proof gloves.
Install the new saw blade. Insert it first through both saw

blade guide bearings and then lay them onto the
flywheels.
ATTENTION: Take care to install the saw band correctly!

Check the direction of the teething.
Tension the saw band with hand wheel.

You can check the tension by applying in the middle of the

free blade section a pressure of approx. 50Nm on the
blade side. The blade is tensioned correctly, if it can be
moved 3mm sidewards out of the straight cutting line.
Turn by hand a flywheel and check the saw band for

straight run
15.3

Gearbox

In normal conditions the gear oi (ISO 220) must be changed after
100 operation hours and after all changes of gears.
15.4

Cleaning

After each workshift the machine has to be cleaned. Remove chips etc. with a suitable tool. Do
not remove them by hand (cutting injury!). Remove dust as well.
The usage of certain solutions containing ingredients damaging metal surfaces
as well as the use of scrubbing agents will damage the machine surface!
Clean the machine surface with a wet cloth soaked in a mild solution
15.5

Disposal

Do not dispose the machine in residual waste. Contact your local authorities for
information regarding the available disposal options. When you buy at your local
dealer for a replacement unit, the latter is obliged to exchange your old.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T I C E
MAINTENANCE
32
BS 712TOP