Shutting Down; Transport; Storage; Care And Maintenance - Kärcher IVL 50/24-2 Originalbetriebsanleitung

Clean the container
Note: Water based cooling lubricants can
cause a bacterial contamination. These
sediments can plug up the openings and
gaps in the filter basket. Wear appropriate
protective gear during the removal.
 Empty the container and filter basket.
 Remove the sediments from the con-
tainer and the filter basket.
 Dispose of the sediments, container
and filter basket contents according to
the applicable rules and regulations.

Shutting down

 Empty the liquid container.
 Empty the filter basket for solids.
 Switch off the appliance using the On/
Off switch.
 Dismantle the accessory and rinse it
with water and let dry if necessary.
Note: Empty the vacuum cleaner after
each use and let it dry with the container
open.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you transport
it.
 When transporting in vehicles, secure
the appliance according to the guide-
lines from slipping and tipping over.

Storage

CAUTION
Risk of injury and damage! Note the weight
of the appliance in case of storage.
This appliance must only be stored in inte-
rior rooms.

Care and maintenance

 Rinse the appliance and the accesso-
ries with fresh water at regular intervals
and let them dry.
 In order to avoid bacteria, do not leave
the chips and liquids inside the appli-
ance.
 During extended operation breaks,
open the cover to let the residual mois-
ture escape.

Troubleshooting

DANGER
First pull out the plug from the mains before
carrying out any tasks on the machine.
DANGER
Have all checks and works on electrical
parts performed by an expert.
Motor (suction turbine) does not
– Liquid container filled.
 Empty the liquid container.
 Empty the filter basket.
– No electrical voltage.
 Check the receptacle and the fuse of
the power supply.
 Check the power cable and the power
plug of the device.
– Fill level probe is dirty.
 Carefully clean the fill level probe.
– Proximity switch distorted.
 Check the position of the proximity
switch (indicator lamp of a proximity
switch must be illuminated).
Suction capacity decreases slowly
– Nozzle, suction hose or suction pipe
may be blocked.
 Check, clean accessories.
– Filter is dirty.
 Clean filter.
Emptying the liquid container is
taking very long
– Drain hose crushed or obstructed.
 Check the drain hose and the valve and
clean them.
Indicator lamp on electric box is on
The indicator lamp glows when the contain-
er is full. If the indicator lamp glows when
the container is empty, there is a fault which
has to be fixed by the Kärcher customer
service.
– 5
EN
start
15