Dry Vacuum Cleaning; Wet Vacuum Cleaning; Shutting Down - Kärcher SE 4002 Bedienungsanleitung

End wet cleaning process
 Rinse the spray tubes in the appliance
as follows:
Fill the detergent container with about 1
liter of clear water.
Hold the nozzle above the drain, and
switch on the spraying pump until the
clear water has been consumed.

Dry vacuum cleaning

Caution
Always work with the filter bag inserted, ex-
cept when a cartridge filter is used (option).
The reservoir and accessories must be dry
to prevent parts from sticking together.
Illustration
 Insert a filter bag.
Illustration
 Use the adapter for wet/dry vacuuming
Attach the adapter to the handle, turn
the locking handle to secure it.
 Select the desired accessories and at-
tach to the spray/suction pipes or direct-
ly to the attachment.
 Switch on suction (position I).
Vacuuming hard surfaces
Illustration
 Insert the hard surface inlay into the
floor nozzle. The bristles should point
towards the front.
Vacuuming carpeted floors
Illustration
 Work without the hard surface insert.
 Use the surrounding air separator to
adapt the suction force.
Note: Close the surrounding air separa-
tor again after use!
18

Wet vacuum cleaning

Caution
Do not use a filter bag!
Immediately switch the appliance off or pull
the power plug if foam forms or liquids es-
cape!
Note: If the container is full a float closes the
suction opening and the appliance works at
a higher speed. Switch off the appliance im-
mediately and empty the container.
 Use wash nozzles to vacuum moisture
or wetness.
If you use a crevice nozzle:
 Attach and secure the adapter for wet/
dry vacuuming. Install the crevice noz-
zle directly to the adapter.
 Switch on suction (position I).
Illustration
 Open the surrounding air separator if
water is suctioned from a tank. Close it
again after use.
 Empty the full reservoir (refer to chapter
"Empty reservoir").

Shutting down

 Turn off the appliance.
 Empty the full reservoir (refer to chapter
"Empty reservoir").
 Rinse the reservoir thoroughly with
clear water.
 Separate the handle, the spray/suction
hoses and the wash nozzle from each
other; open locking lever to achieve this
(centre position),
 Flush the accessories separately under
running water and let air dry.
 Clean the foam filter under running wa-
ter; let it dry before reinserting it.
 Leave the appliance open to let it dry.
 Storing the appliance. Store the ac-
cessories on the appliance and store in
dry rooms.
– 10
EN