Remote Control; Shutting Down; Emptying The Vacuuming Material Container; Lp Appliances - Kärcher IVS 100/55 Originalbetriebsanleitung

Remote control

The appliances
 IVS 100/55
 IVS 100/75
 IVS 100/55 LP
 IVS 100/75 LP
are equipped with a radio receiver for the
remote control option.
The training time and operation are de-
scribed in the operating instructions of the
remote control.

Shutting down

 Switch off the appliance using the On/
Off switch.
 If necessary, dismantle the accessory
and rinse it with water and let dry.
 Empty the vacuuming material contain-
er (refer chapter "Emptying vacuuming
material container").
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
Emptying the vacuuming material
Note
The vacuum material container must be
emptied when it is has filled up to approx. 3
cm below the upper edge.
Regularly check the filling level in the dirt
receptacle, since the device does not
switch off automatically.
 Switch off the appliance and secure it
using the parking brakes at the guide
rollers.
 Open the vacuum material container
upwards at the unlocking mechanism.
18
container
 Pull out the vacuuming material con-
tainer from the appliance using the han-
dle that has been provided for the pur-
pose.
 Empty the vacuuming material contain-
er and insert it back into the appliance
using the reverse sequence.
Note
The vacuum material container can be lift-
ed by cranes at the handle. Maximum load
for crane transport: 50 kg.
CAUTION
Risk of injury and damage! Note the total
weight of the vacuum material container
when transporting with a crane. Do not
overload the container. Observe instruc-
tions on lifting with a crane.
Dust collection bag
You can insert a dust collector in the vacu-
uming material container to empty the ap-
pliance without causing dust.
Do not use the dust collection bag for wet
vacuum cleaning!
 Insert the dust collection bag into the
container and attach it carefully to the
container wall.
 Put over the edge of the bag over the
rim of the vacuuming material contain-
er.
 Insert the vacuuming material container
back into the appliance.
 After finishing use, close the dust col-
lection bag and remove it from the vac-
uuming material container.
 Dispose off the dust collection bag with
its contents according to the applicable
regulations.
Remove the disposal system
 Lock parking brakes.
 Remove the tin tub.
 Pull the locks of the placement mechan-
ics up.
 Pull the push handle upward. The dis-
posal system is unlocked and lowered.
 Pull the disposal system out by the han-
dle.
– 6
EN

LP appliances