Bring the appliance to working position
- secure it, if required, with parking
brakes.
Insert the suction hose into the suction
hose connection.
Attach the desired accessoried to the
suction hose.
Ensure that the vacuum material con-
tainer has been inserted properly.
Operation
Insert the appliance plug into the mains
socket.
Switch on the appliance using the ON/
OFF switch.
Monitoring the suction performance
There is a manometer on the front side of
the appliance; this indicates the suction un-
der-pressure in the device. If the under or
negative pressure falls below -0.16 bar (-16
kPa), then you must switch off the appli-
ance and clean the filter.
Switch off the appliance using the On/
Off switch.
Clean the filter (see chapter "Cleaning
the filter").
Dry vacuum cleaning
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter ele-
ment is still wet the filter will become ob-
structed and may be damaged beyond re-
pair.
Dry the wet filter properly before use or
replace it with a dry one.
Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
14
Start up
Wet suction (optional)
Note: Wet vacuum cleaning is only permit-
ted when using the vacuuming cleaner
waste container for wet vacuum cleaning.
The floater switch in the container for wet
vacuuming interrupts the suction flow when
the maximum filling level is reached.
When the suction flow is interrupted by the
floater switch:
Switch off the appliance using the On/
Off switch.
Drain off the liquids by opening the
drain valve located at the base of the
container.
Shutting down
Switch off the appliance using the On/
Off switch.
If necessary, dismantle the accessory
and rinse it with water and let dry.
Empty the vacuuming material contain-
er (refer chapter "Emptying vacuuming
material container").
Vacuum and wipe the appliance inside
and outside with a damp cloth.
Emptying the vacuuming material
Switch off the appliance and secure it
using the parking brakes at the guide
rollers.
Open the vacuuming material container
upward at the lock (see figure).
– 4
EN
container