Herunterladen Diese Seite drucken

Operation; Shutting Down - Kärcher IV 100/55 H B1 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für IV 100/55 H B1:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Operation

WARNING
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded.
In case of confusion regarding the power
impedance present on your connection,
please contact your utilities provider.
 Turn on/off switch to "1".
Warning
Avoid rolling up or bending the hose while
using the vacuum cleaner.
Safety filter bag
You must insert a safety filter bag into the
vacuuming material container to empty the
appliance without causing dust:
 Insert the safety filter bag into the con-
tainer and attach it carefully to the con-
tainer wall.
 Put over the edge of the bag over the rim
of the vacuuming material container.
 Insert the vacuuming material container
back into the appliance.
 After use, close the safety filter bag and
remove it from the vacuuming material
container.
 Dispose of the safety filter bag with its
contents according to the applicable
regulations.
Monitoring the suction performance
The machine is equipped with a suction
power monitor. If the air speed in the suc-
tion hose falls below 20 m/s, the manome-
ter will display 19.5 kPa:
Perform the following activities to regain the
prescribed air speed of more than 20 m/s:
 Switch off the appliance using the On/
Off switch.
 Clean the filter (see chapter "Cleaning
the filter").
 Check suction hose and attachments
for blocks.
If these measures do not lead to the de-
sired reduction in pressure display:
 Switch off the machine and replace the
filter (see chapter "Replacing filter").

Shutting down

 Switch off the appliance using the On/
Off switch.
 If necessary, dismantle the accessory
and rinse it with water and let dry.
Note
Empty the vaccum cleaner after every use
and clean only when required.
 Empty the vacuuming material contain-
er (refer chapter "Emptying vacuuming
material container").
 Vacuum and wipe the appliance inside
and outside with a damp cloth.
 Place the appliance in a dry room and
secure it from unauthorized use.
 While vacuuming the appliance, use at
least one vacuum cleaner of the same
or higher classification.
Emptying the vacuuming material
To avoid too much filling of the vacuuming
material container, you need to check it
regularly depending on the type and vol-
ume of the sucked in material.
 Switch off the appliance and secure it
using the parking brakes at the guide
rollers.
 Properly insert the cap into the suction
connection.
 Lift the lock and push the cap in until it
locks into place.
 Open the vacuuming material container
upward at the lock (see figure).
– 5
EN
container
17

Werbung

loading