Shutting Down - Kärcher Puzzi 8/1 C Handbuch

Cleaning tips
Highly soiled spots should be pre-
–
soaked and the detergent solution
should soak 5 to 10 minutes.
Always work from the light to the shade
–
(from the window to the door).
Always work from the cleaned to the un-
–
cleaned surface.
The more sensitive the surface (oriental
–
rugs, berbers, upholstery material) the
lower the cleaning solution concentra-
tion should be.
Rugs with jute backing can shrink if too
–
much water is used and can bleed col-
ours.
Brush high-fiber rugs in the direction of
–
the weave after cleaning (using a fiber
brush or a scrubber).
Water-proofing the fabric using Care
–
Tex RM 762 after the wet cleaning pre-
vents a quick resoiling of the textile sur-
face.
Do not step on cleaned surfaces until
–
they have dried and do not place furni-
ture on them to avoid pressure spots or
rust stains.
When cleaning previously shampooed
–
carpets, foam will be generated in the
dirt water reservoir. In such a case add
Foam ex RM 761 to the dirt water reser-
voir.
Detergent
Carpet and upholstery
cleaning
Defoaming
Waterproofing carpets
Mite removal
If you require further information please re-
quest the product information sheet and the
DIN safety data sheet for the respective
cleaning agent.
12
RM 760 powder
RM 760 tabs
RM 764 liquid
RM 760
RM 762
RM 765 Mitex
EN

Shutting down

Empty the fresh water reservoir
 Switch off the spray and suction switches.
 Shortly activate the lever on bender to
decrease the pressure.
 Separate bender from the spray/suction
hose.
 Remove the lid.
see Figure 7
 Insert the suction hose into the fresh
water reservoir.
 Press the suction switch to turn on the
suction turbine.
 Remove the lid.
 Empty the fresh water reservoir and
switch the appliance off.
see Figure 8
 Remove the dirt water reservoir from
the appliance and empty it.
Cleaning the device
 Connect the bender (with suction pipe
and nozzle) to the suction hose.
 Connect the coupling of the fresh water
hose to the bender and lock into place.
see Figure 9
 Fill approx. 2 litres of fresh water into
the fresh water reservoir.
Do not add any detergents.
see Figure 10
 Place nozzle into the dirt water reservoir.
 Press the spray switch to turn on the de-
tergent pump.
 Activate lever on bender and flush the
appliance for appr. 1 to 2 minutes.
 Turn off the appliance.
 Disconnect the mains plug from the
socket.
see Figure 11
 Remove the dirt water reservoir from
the appliance and empty it.
 Clean the external surfaces of the appli-
ance.
 Coil power cable around the carrying han-
dle and the lid (see overview on title page).
– 3