Shutting Down; Maintenance And Care - Kärcher SE 4002 Bedienungsanleitung

Wet vacuum cleaning
Caution
Do not use a filter bag!
Immediately switch the appliance off or pull
the power plug if foam forms or liquids es-
cape!
Note: If the container is full a float closes
the suction opening and the appliance
works at a higher speed. Switch off the ap-
pliance immediately and empty the contain-
er.
 Use wash nozzles to vacuum moisture
or wetness.
If you use a crevice nozzle:
 Attach and secure the adapter for wet/
dry vacuuming. Install the crevice noz-
zle directly to the adapter.
 Switch on suction (position I).
Illustration
 Open the surrounding air separator if
water is suctioned from a tank. Close it
again after use.
 Empty the full reservoir (refer to chapter
"Empty reservoir").

Shutting down

 Turn off the appliance.
 Empty the full reservoir (refer to chapter
"Empty reservoir").
 Rinse the reservoir thoroughly with
clear water.
 Separate the handle, the spray/suction
hoses and the wash nozzle from each
other; open locking lever to achieve this
(centre position),
 Flush the accessories separately under
runningn water and let air dry.
 Clean the foam filter under running wa-
ter; let it dry before reinserting it.
 Leave the appliance open to let it dry.
 Storing the appliance. Store the ac-
cessories on the appliance and store in
dry rooms.

Maintenance and Care

Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
Clean the spray nozzle
With an uneven spray jet.
Illustration
 Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
Clean the sieve in the fresh water
1 x year or as needed.
Illustration
 Turn the lock and loosen it. Take out
the sieve and rinse it with water.
No water exiting from nozzle
 Fill up fresh water reservoir.
 Check the fresh water reservoir for cor-
rect fit.
 Detergent pump defective, contact Cus-
tomer Service.
Spray stream uneven
 Clean the spray nozzle of the wash noz-
zle.
Insufficient vacuum performance
 Close the surrounding air separator at
the handle.
See diagram 11
 Accessories, suction hose or suction
tubes are clogged, please remove the
obstruction.
 Filter bag is full, insert a new filter bag
(for the order no. please see the spare
parts list at the end of the present in-
structions).
 Cleaning the foam filter
– 6
EN
reservoir
Faults
17