Blender - Silvercrest SKM 500 B1 Bedienungsanleitung

Blender

GB
Fig. 3
74
6) Slide the pusher 1 into the fi lling shaft 2.
7) Insert the plug into the mains power socket.
NOTE
► Use the diagrams on the fold-out page for assembly assistance!
1) Place the blender onto the motor block o in a central position so that the
on the holder with mixing knife 9 is pointing at the symbol
arrow
2) Turn the blender until the arrow
3) Fit the lid 6 to the blender 7 so that the lip of the lid 6 is exactly in line with
the handle of the blender 7 (Fig. 3). Ensure that the lip is positioned exactly at
the side next to the handle towards which the guide at the handle opens.
Rotate the lid 6 clockwise so that the locking mechanism on the lid 6 en-
gages in the guide at the handle of the blender 7 (Fig. 4). Press the lip down
a little way to ensure that the locking mechanism has engaged in the slot.
4) Fit the blender closure 5 to the lid 6 of the blender so that the plastic tabs
slide into the guides in the lid 6. Then rotate the closure 5 by 90°, so that
it is fi rmly attached.
5) Insert the plug into the mains power socket.
is pointing at the symbol
Fig. 4
.
.
SKM 500 B1