Adding Ingredients; Using The Blender Jug - Silvercrest SKMP 1300 C2 Bedienungsanleitung

Adding ingredients

• You can add ingredients into the mixing
bowl 15 while the drive arm 22 is lift-
ed up.
• During mixing, you can add ingredients
through the filling opening 20 in the
splash guard 21:
- Reduce the speed to 1 - 2.
- Open the flap of the filling open-
ing 20.
- Add the ingredients.
- Close the flap of the filling open-
ing 20 again.
Lowering the drive arm
9. Rotate the unlocking lever 10 upwards
in the direction of the arrow.
10.Move the drive arm 22 all the way
down. The unlocking lever 10 jumps
back to the vertically locked position.
The device is now fully assembled. On work-
ing with the device: see "Basic operation"
on page 12.

8. Using the blender jug

NOTE: when you use the blender jug 5, the
axle 23 also turns. The mixing bowl 15 and
splash guard 21 should therefore also be
mounted, but not a mixing tool.
Mounting the blender jug
1. Remove the cover 8 to the right.
2. Position the blender jug 5 on the drive
unit 7 so that the white arrow ( ) on
the bottom of the blender jug points to
the open lock symbol.
3. Turn the blender jug 5 clockwise until it
is firmly in place. The white arrow ( )
now points to the closed lock symbol.
Adding ingredients
• First add the liquid ingredients to the
blender jug 5, and then the solid ones.
• Cut the solid ingredients into small piec-
es in advance, so that the pieces do not
get jammed in the blades.
• During blending, you can add ingredi-
ents through the refill opening 3 in the
lid 2:
- Reduce the speed to 1 - 2.
- Rotate the lid of the refill opening 1
anticlockwise and remove it.
- Add the ingredients.
- Replace the lid 1 such that the small
plastic nibs fit into the recesses at the
refill opening 3.
- Turn the lid 1 clockwise until it is firm-
ly in place.
11
GB