Adding Ingredients; Using The Blender Jug - Silvercrest SKMP 1300 D3 Kurzanleitung

6. Place the mixing tool 20/21/22 onto
the axle 23 from below.

Adding ingredients

• You can add ingredients into the mixing
bowl 16 while the drive arm 19 is lift-
ed up.
Lowering the drive arm
DANGER of hand injuries by
crushing!
Never put your hands between the drive
arm and the housing. There is a risk of
injury from crushing when folding
down.
7. Press the unlock button 11 and move
the drive arm 19 all the way down.

Using the blender jug

DANGER! Risk of injury from
cutting!
Please remember that the blades of the
blade assembly 7 are very sharp.
Using and removing the blade
assembly
The blender jug 5 must never be used with-
out the blade assembly 7, since the blade
assembly 7 seals the blender jug 5 on the
bottom.
In order to remove the blade assembly 7,
proceed as follows:
1. Turn the blender jug 5 upside down.
2. Turn the blade assembly 7 clockwise at
the two handles 25 until the knife as-
r b o
T u sembly comes loose.
3. Pull out the blade assembly 7 carefully.
25
In order to insert the blade assembly 7, pro-
ceed as follows:
1. Turn the blender jug 5 upside down.
2. Place the blade assembly 7 carefully
into the blender jug 5.
25
17
GB