Introduction; Product Description (Fig. 1-18); Scope Of Delivery (Fig. 2); Proper Use - Parkside Pbks 53 C3 Bedienungs- Und Sicherheitshinweise

3

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new product brings you much enjoy-
ment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this product assumes no lia-
bility for damage to the product or caused by the prod-
uct arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
Note:
The operating manual is part of this product.
It includes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes and
for increasing the reliability and extending the service
life of the product. In addition to the safety instructions
in this operating manual, you must also observe the
regulations applicable to the operation of the product
in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the prod-
uct on to third parties.
4

Product description (Fig. 1-18)

1. Front hand guard (chain brake)
2. Front handle
3. Air filter cover
3a. Clip fastener
3b. Air filter screw
3c. Air filter
4. Pull starter
5. On/off switch
6. Fuel pump "primer"
7. Choke
8. Throttle interlock
9. Throttle
10. Rear handle
11. Rear hand guard
12. Fuel tank
12a. Fuel filler cap
12b Bracket
13. Oil tank
13a. Oil tank cover
13b. Bracket
14. Claw stop (pre-assembled)
15. Guide bar (guide rail)
16. Saw chain
17. Bench grinder aid
18. Adjusting screw (saw chain lubrication)
19. Chain tensioning screw
19a. Chain tensioning pin
19b. Hole
20. Chain cover
20a. Fixing nuts
21. Chain catcher
22. Chain wheel
23. Saw chain oil (organic)
24. Oil-petrol mixing bottle
25. Installation spanner
26. Guide bar and chain guard
27. Spark plug connector
28. Felling marks
5

Scope of delivery (Fig. 2)

Item Quantity Designation
15. 1 x Saw (guide rail)
(pre-assenbled)
16. 1 x Saw chain
(pre-fitted)
20. 1 x Chain cover
23. 1 x Saw chain oil (organic)
24. 1 x Oil-petrol mixing bottle
25. 1 x Installation spanner
26. 1 x Guide bar and chain guard
1 x Petrol chainsaw
1 x Operating manual
6

Proper use

The petrol chainsaw is designed for sawing wood only.
The product is not intended for any other types of ap-
plication (e.g. cutting masonry, plastic or food).
The product may only be used in the intended manner.
Any use beyond this is improper. The user, not the
manufacturer, is responsible for damages or injuries of
any type resulting from this.
An element of the intended use is also the observance
of the safety instructions, as well as the assembly in-
structions and operating information in the operating
manual.
Persons who operate and maintain the product must
be familiar with the manual and must be informed
about potential dangers.
The liability of the manufacturer and resulting damages
are excluded in the event of modifications of the prod-
uct.
GB / CY | 5