Cascading Repeaters - Auerswald COMfortel DECT 900 Installation Und Konfiguration

After the repeater has been re-started, the LED will remain lit.
Note:
The repeater registration is now finished. The repeater can be disconnected from its
power source and mounted at the desired location (the registration will not be deleted
by the power interruption).
As an alternative to pressing the Paging key, you can switch the base station to regis-
tration mode by clicking Activate registration mode from within the PBX's configu-
ration program / manager.
If after pressing the call control button on the handset, you hear static noise within a
repeater's reception area, an RPN may have been assigned twice. Check the
assigned RPNs
an RPN has been assigned twice, re-register one of the affected repeaters using a
free RPN. If the noise you are hearing is a continuously repeated signal, you can
disable it (chapter

Cascading Repeaters

You can register up to six repeaters with a base station. Two of the six can be cascaded. The repeater
that is to be connected with the base station through another repeater must be re-programmed on a
PC (in our example, Repeater 4 in
Requirements:
– Configuration tool COMfortel DECT Repeater.2 Tools (avai-
lable separately, consisting of: adapter, PC cable for the V.24
interface, Windows configuration software)
– PC to run the configuration tool software
– Repeaters registered with base station
Determining the Identification Number (RFPI)
1. Disconnect the repeater that is to serve as the connector
(in our example, Repeater 3 in
source, and unplug the RJ-45 plug on the back of the repeater.
(chapter Querying the Radio Signal Strength or RPN on page
Repeater Signal on page
Abb. 9).
Abb. 9) from its power
Commissioning the System
82).
Repeaters
83). If
Abb. 9
RPN e. g.:
5
2 1 3 4
6
65