Inhaltsverzeichnis
Werbung
CHASSIS ELECTRICAL
Antenna going down
Antenna going up
REMOVAL SERVICE POINT
Raise and remove the seat cushion with the lever pulled.
INSTALLATION SERVICE POINT
(1) Securely fit the attachment wire of the seat cushion
under the seatback.
(2) Pass the inner seat belt buckles through the cushion.
(3) Securely fit the lock plates of the seat cushion into
the holes in the floor.
INSPECTION
ANTENNA MOTOR INSPECTION
Disconnect the motor antenna control unit connector, connect
the positive terminal of the power supply to terminal (1) and
connect the negative terminal to terminal (4) to check that
the antenna goes up, and that when the connections are re-
versed, the antenna goes down.
MOTOR ANTENNA CONTROL UNIT INSPECTION
(1) Connect the harness connector to the motor antenna.
(Body harness)
(2) Disconnect the antenna motor connector.
(3) With the ignition switch in the ACC or ON position, operate
the radio switch and check the voltage between the termi-
nals during the period when the antenna is going up or
going down.
Antenna operating
direction
Down
00002406
TSB Revision
Terminals to check
Voltage (V)
l - 3
10-13
3 - 4
I
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
