Starter Relay - Mitsubishi MOTORS 3000GT Bedienungsanleitung

ENGINE ELECTRICAL - Starting System
MAGNETIC SWITCH RETURN TEST
(1) Disconnect field coil wire from M-terminal of magnetic
(2) Connect a 12 V battery between M-terminal and body.
Field coil wire
(3) Pull pinion out and release. If pinion quickly returns to

STARTER RELAY

(1) Remove the starter relay from the relay box.
(2) Connect battery to terminal 2 and check continuity between
TSB Revision
switch.
Caution
This test must be performed quickly (in less than 10
seconds) to prevent coil from burning.
its original position, everything is in order. If it doesn't,
replace magnetic switch.
Caution
When pulling out the pinion, be careful not to have
your finger pinched.
terminals with terminal 4 grounded.
3-4 terminals
Power is supplied
3-5 terminals
3-4
Power is not
3-5 terminals
supplied
l-2 terminals
No continuity
Continuity
terminals Continuity
No continuity
Continuity