Mitsubishi MOTORS 3000GT Bedienungsanleitung Seite 680

CHASSIS ELECTRICAL - Radio and Tape Plaver
POWER button Disp'ay PROG button
PROG button
Display
POWER button
PROG button
POW'ER button
Display
section
Typical security code "5283"
2. Return power supply for the radio and player to the normal
state.
3. Turn the ignition key to the "ACC" position.
4. Press the POWER button, and "code" will be displayed
on the display.
Memory
select
button
Memory
00002402
5. Press No.1 through No.4 memory select buttons and set
the 4-digit security code indicated on the card.
Every time each digit key is pressed, the number changes
as follows:
6. Press the PROG button. After a beep is heard, the radio
and tape player will be in the operating state.
7. If the input security code does not agree with that in
memory, "1 Err" is displayed on the display. In a few se-
conds, it will change to "code". So, repeat steps 4 and
5.
NOTE
(1) The security code can be set three times at the most.
(2) The second error is displayed as "2 Err". If the third
(3) When setting is attempted four or more times, keeping
error is made, "3 Err" is displayed and then it changes
to "OFF".
the ignition key in the "ACC" or "ON" position for about
one hour will automatically erase the "OFF" display.