Mitsubishi MOTORS 3000GT Bedienungsanleitung Seite 500

CHASSIS ELECTRICAL - Battery
4. Clean top of battery with same solutions as described
in step (3).
5. Inspect battery case and cover for cracks. If cracks are
present, battery must be replaced.
6. Clean the battery post with a suitable battery post cleaning
7. Clean the inside surfaces of the terminal clamps with a
suitable battery terminal cleaning tool. Replace damaged
or frayed cables and broken terminals clamps.
8. Install the battery in vehicle.
9. Connect (+) and (-) cables to battery in the order of men-
tion.
10. Tighten the clamp nut securely.
BATTERY CHARGLNG
Caution
When batteries are being charged, an explosive gas forms
beneath the cover of each cell. Do not smoke near batteries
on charge or which have recently been charged. Do not
break live circuits at the terminals of the batteries on
charge. A spark will occur where the live circuit is broken.
Keep all open flames away from the battery.
Battery electrolyte temperature may temporarily be allowed
to rise to 55°C (131°F). Increase of electrolyte temperature
above 55°C (131 OF) is harmful to the battery, causing deforma-
tion of battery cell, decrease in life of battery, etc.
CHARGE RATE
If the test indicator is white, the battery should be charged
as outlined below.
When the dot appears or when maximum charge shown below
is reached, charging should be stopped.
NOTE
When the charging is performed at 5 amps, charging is virtually
100% three hours after the indicator's indication changes from
white to green.
Use fast charging only in an emergency.
If the indicator does not turn to green even after the battery
is charged, the battery should be replaced; do not overcharge.
Charge Rate Chart
TSB Revision
Slow Charging Fast Charging
I