Output Current Test - Mitsubishi MOTORS 3000GT Bedienungsanleitung

(6) Connect a tachometer. (For the procedure for
connecting the tachometer, refer to GROUP
(7) kkconnect the negative battery cable.
(8)
Leave the hood open.
(9) Start the engine.
(lO)With the engine running at 2500 rpm, turn the
headlights and other lights on and off to adjust
the generator load so that the value displayed
on the ammeter is slightly above 30A.
Limit value: Max. 0.3 V
NOTE
When the generator output is high and the value
displayed on the ammeter does not decrease
to 30A, set the value to 40A. Read the value
displayed on the voltmeter at this time.
In this case the limit value becomes max. 0.4V.
Adjust the engine speed by gradually decreas-
ing it until the value displayed on the ammeter

OUTPUT CURRENT TEST

30A
Battery
ENGINE ELECTRICAL - Charging System
Charging indicator
Voltmeter
is 30A. Take a reading of the value displayed
on the voltmeter at this time.
(11) If the value displayed on the voltmeter is above
the limit value, there is probably a malfunction
in the generator output wire, so check the wiring
between the generator "IS" terminal and the bat-
tery (+) terminal (including fusible link).
If a terminal is not sufficiently tight or if the har-
ness has become discolored due to overheating,
repair and then test again.
(12)After the test, run the engine at idle.
to the OFF position.
(14)Disconnect the negative battery cable.
eter.
(16)Connect the generator output wire to the genera-
tor "B" terminal.
(17)Connect the negative battery cable.
Generator
Ammeter
Load