Mitsubishi MOTORS 3000GT Bedienungsanleitung Seite 64

CIRCUIT DIAGRAMS - How to Read Circuit Diagrams
The circuit of each system from the fuse (or fusible link) to ground is shown. The power supply is shown
at the top and the ground at the bottom to facilitate understanding of how the current flows.
Indicates harness junction point
No. for another system. It corre-
Indicates the circuit name to be
Indicates the powersupply in the B
control unit. If no voltage is dis-
played, this indicates battery
positive voltage.
An "X" at the end of a connector
No. indicates that the connector
is connected to a centralized
junction that is shown in the sec-
tion "Centralized Junction".
Indicates the operating condi-
Indicates connector No. The same No. as
in the wiring harness diagram is used. Con-
nector numbers enclosed by frame are indi-
cated with the connector symbols at the
lower part of the page. Connector numbers
not enclosed by frame are indicated without
connector symbol.
Indicates the connector symbol.
are indicated in numerical order.
Revision
TSB
Indicates the circuit name to be
connected. The arrow indi-
cates the current flow direction.