Inhaltsverzeichnis
Werbung
CHASSIS ELECTRICAL - Meters and Gauaes
ENGINE COOLANT TEMPERATURE GAUGE SIMPLE CHECK
Remove the water temperature gauge
unit coupling connector.
Connect the harness connector via a
test light to the ground.
Place the ignition switch in the ON posi-
tion.
Check the test light and gauge conditions.
ENGINE COOLANT TEMPERATURE GAUGE UNIT CHECK
To check, remove engine coolant temperature gauge unit from
the thermostat housing.
Engine Coolant Temperature Gauge Unit Resistance
(1) Immerse unit in 70°C (158OF) water to measure resistance.
Standard value: 104 f 13.5 Sz
(2) After checking, apply the specified sealant around the
thread of engine coolant temperature gauge unit and install
on the thermostat housing.
Specified sealant:
3M Nut Locking Part No. 4171 or equivalent
TSB Revision
Replace water temperature gauge unit.
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
