Mitsubishi MOTORS 3000GT Bedienungsanleitung Seite 501

BATTERY TESTING PROCEDURE
TEST STEP
(1) Remove hold-downs and shields.
(2) Check for broken/cracked case or cover.
OK
(1) Turn headlights on for 15 seconds.
(2) Turn headlights off for 2 minutes to allow battery voltage to
stabilize.
(3) Disconnect cables.
(4) Read open circuit voltage.
OK: Open circuit voltage is more than 12.4V.
(2) Load the battery at the recommended discharge rate (see
LOAD TEST RATE CHART) for 15 seconds.
(3) Read voltage after 15 seconds, then remove load.
(4) Compare the measured value with the minimum voltage. (See
OK: Higher than the minimum voltage
Normal
LOAD TEST RATE CHART
Load test Cranking
rating (0°F) capacity
240 amps 520 amps
CHASSIS ELECTRICAL -
NG
NG
16 (60)
9.5
Reserve Application
123 minutes 75D23R-MF
Battery
Clean terminals and clamps.
Re-test