Herunterladen Inhalt Inhalt Diese Seite drucken

Mitsubishi MOTORS 3000GT Bedienungsanleitung Seite 28

1992-1996+
Inhaltsverzeichnis

Werbung

GENERAL - Harness Connector Inspection
Front holder
Housing lance 7,fiEL,
00000400
Terminal lance
RECTANGULAR WATERPROOF CONNECTOR
(1) Disengage front holder by using a screwdriver and remove
it.
(2) Inset-t tip of screwdriver [*0.8 mm (.03 in.) width] into con-
nector in a manner as shown in the figure, push it lightly
to raise housing lance and pull out harness.
*If right size screwdriver is not available, convert a conven-
tional driver to suit the size.
(3) Press contact point of male terminal down by holding a
screwdriver [1.4 mm (.06 in.) width] in a manner as shown
in the figure.
INJECTOR CONNECTOR
(1) Remove waterproof cap.
(2) Insert tip of screwdriver [1.4 mm (.06 in.) width] into connec-
tor in a manner as shown in the figure, press in terminal
lance and pull out harness.
(3) Press contact point of male terminal down by holding a
screwdriver [1.4 mm (.06 in.) width] in a manner as shown
in the figure.
Caution
Make sure that lance is in proper condition before
terminal is inserted into connector.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis