Inhaltsverzeichnis
Werbung
CHASSIS ELECTRICAL - Meters and Gauges
Free r&Hers -
Anchor plate
bracket
INSPECTION
SPEEDOMETER CHECK
(1) Assure tire pressure at standard value. (Refer to GROUP
(2) Gt the vehicle on a speedometer tester.
(3) Set free rollers securely on the floor according to the wheel-
base and rear tread of the vehicle (when rear wheels
are to be set on free rollers).
(4) Raise the rear wheels on a jack and place rigid racks
to support the specified positions of the side sills (when
rear wheels are to be raised on a jack).
(5) Make sure the parking brake has been set. cPWD>
(6) Attach anchoring bars on the tie-down brackets and secure
their ends to the anchor plates.
(7) Make sure the tension on the right and left bars is the
same. Also be sure there is enough tension on each bar.
(8) Attach a chain or wire to the rear tie-down hole. Make
sure the end of the wire or chain is secured firmly.
(9) Take all other necessary precautions.
indication error.
Standard value:
Standard indication
20
40
80
Caution
Do not operate the clutch or accelerator abruptly or
decelerate during the operations.
TSB Revision
Allowable range mph
19-22
38-44
57-66
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
