Inhaltsverzeichnis
Werbung
ENGINE ELECTRICAL - Charging System
(3) Clamp the rotor in a vise with soft jaws.
(4) After removing the nut, remove the pulley and front
REMOVAL
(1) When removing the stator, unsolder stator lead wire
(2) When removing the brush holder, unsolder it from
REASSEMBLY SERVICE POINT
Before rotor is attached to rear bracket, insert wire through
small hole made in rear bracket to lift brush. After rotor
has been installed, remove the wire.
Wire
3
TSB Revision
bracket from the rotor.
from the main diode of the rectifier.
the rectifier.
Caution
(1) When soldering or unsoldering, be careful to
make sure that heat of soldering iron is not
transmitted to diodes for a long period. Finish
soldering or unsoldering in as short a time
as possible.
(2) Be careful that no undue force is exerted to
leads of diodes.
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
