Brush Replacement - Mitsubishi MOTORS 3000GT Bedienungsanleitung

Soldered
ENGINE ELECTRICAL - Charging System
(2) Negative Rectifier Test
Check for continuity between negative rectifier and stator
coil lead connection terminal. If there is continuity in both
directions, diode is shorted, and rectifier assembly must
be replaced.
(3) Diode Trio Test
Check three diodes for continuity by connecting an amme-
ter to both ends of each diode. If there is no continuity
in both directions, diode is faulty and heatsink assembly
must be replaced.
BRUSH REPLACEMENT <Up to 1995 models>
(1) Replace brush by the following procedures if it has been
worn to limit line.
(2) Unsolder pigtail and remove old brush and spring.
(3) Install brush spring and new brush in brush holder.
(4) Insert the brush to where there is a space 2 to 3 mm
the brush holder.
TSB Revision