Mitsubishi MOTORS 3000GT Bedienungsanleitung Seite 597

Stopper
Center b
Vertical angle gauge
Gear (6)
CHASSIS ELECTRICAL
VERTICAL ADJUSTING
Adjust the vertical angle with the vertical adjusting gear so
that the bubble of the vertical angle gauge is aligned with
the "0" mark position.
NOTE
The beam angle will change about 0'12' with on mark.
HORIZONTAL ADJUSTING
Insert a screwdriver in the horizontal adjusting hole and turn
until the "0" mark and the center line are in alignment.
NOTE
The beam angle will change about 0'23' with on mark.
3. Check to see that the bubble in the headlight vertical angle
gauge is in the illustrated position.
4. If the bubble is out of position, adjust by turning the adjust-
ing screw.
5. Confirm that the "0" mark on the headlight horizontal angle
adjusting gear (B) is in alignment with the center line.
6. If not, perform the adjustment as follows.
(1) Pull up the stopper.
(2) Push the gear (B) in the arrow direction to disengage
(3) Align the "0" mark on the gear (B) with the center
(4) Push down the stopper to engage the gear (B) with
it from the gear (A).
line.
the gear (A).