GRE Salt System CONNECTED Bedienungsanleitung Seite 142

17. Activation/deactivation of pH/ORP drivers
+ +
INFO INFO CAL CAL
Switch on the device
EN
+
INFO CAL
Use the "+" key to enable /
disable the ORP driver
18. Main screen information
+
INFO CAL
Sleep mode
After 60" of inactivity, the device
goes into sleep mode, lowering the
light brightness.
Cover
With the cover activated and closed,
the
and the output percentage will be
adjusted to the set percentage. Circle
shows animation with two different
light tones.
+ +
SET SET INFO INFO CAL CAL SET SET
When the device model
appears, press the
"INFO" key
+
SET INFO CAL SET
Confirm with the
"INFO" key
+
SET INFO
Output setpoint 0%
When electrolysis percentage is 0%,
the device flashes 0% on the output
indicator.
+
INFO CAL SET
"cover" indicator will flash,
(pH KIT and ORP KIT only available for scalable models)
+ +
INFO INFO CAL CAL SET SET
Use the "+" key to enable/
disable the pH driver
+
INFO CAL SET
Leave the device to start up completely, and the pH / ORP drivers will become operational
+
CAL SET INFO
Output setpoint 20 - 100%
When the electrolysis percentage is
between 20 - 100%, the device shows
this value in the output indicator.
+
INFO CAL SET
Polarity indicator.
On the main screen, the device
displays information on the polarity in
which the electrode is working (direct
or reverse).
139
+ +
INFO INFO CAL CAL SET SET
Confirm with the
"INFO" key
+
INFO CAL SET
+
CAL SET
INFO
Boost mode
When boost mode is activated, the
device will be producing at 100% for
24h, and the effect is displayed (0 - 100)
on the output indicator.
+
INFO CAL SET
Alarms
The device indicates the alarms set
at all times.
+
INFO CAL SET
CAL SET