General Characteristics; Safety Warnings And Recommendations - Gre Salt System Connected Bedienungsanleitung

IMPORTANT: This instruction manual contains essential information about the safety measures to be taken during installation
and start up. Therefore, both the installer and the user must read the instructions prior to assembly and start up. Keep this
manual for future reference regarding the operation of this appliance.
Treatment of electrical and electronic devices after their useful life (only applicable in the EU).
Any product marked with this symbol indicates that it cannot be disposed of with other household waste at
the end of its useful life. It is the user's responsibility to dispose of this type of waste by depositing it at a
suitable site for the selective recycling of electrical and electronic waste. The proper treatment and recycling
of this waste makes an essential contribution to the conservation of the environment and the health of users.
For more detailed information on collection points for this type of waste, please contact your local authorities.
The instructions contained in this manual describe the operation and maintenance of Salt Electrolysis systems. In order to
achieve optimum performance of the Salt Electrolysis systems, follow these instructions:

1. General characteristics:

- Once your Salt Electrolysis system is installed, some salt must be dissolved in the water. The Salt Electrolysis system
consists of two elements: an electrolysis cell and a control unit. The electrolysis cell contains a number of titanium plates
(electrodes), so that when an electric current and the saline solution pass through them, free chlorine is produced.
- Maintaining a certain level of chlorine in the pool water will ensure it is sanitary. The Salt Electrolysis system will produce
chlorine when the pool's filtration system (pump and filter) is in operation.
- The device features several safety mechanisms, which are activated in the event of abnormal system operation, as well as
a control microcontroller.
- Salt Electrolysis systems have an automatic cleaning system for the electrodes that prevents scale buildup.
2.

Safety warnings and recommendations:

- Assembly or handling must be carried out by suitably qualified personnel.
- The applicable regulations for accident prevention and electrical installations must be observed.
- In the installation, it must be taken into account that to disconnect the device from electricity, a switch or circuit breaker that
complies with IEC 60947-1 and IEC 60947-3 and ensures the all-pole disconnection must be incorporated. It must be directly
connected to the power supply terminals and must have a contact separation in all its poles that completely disconnects in
cases of category III surge conditions, in an area that complies with the safety requirements of the site. The switch must be
located in the immediate vicinity of the device and must be easily accessible. In addition, this must be marked as the device
cut-off switch.
- The device must be powered by a residual current mechanism that does not exceed 30mA (RDC). The device must be
electrically grounded.
- The manufacturer is in no way responsible for the assembly, installation or startup, nor for any manipulation or incorporation
of components that have not been carried out at the manufacturer's premises.
- This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given suitable supervision or instruction concerning the
safe use of the appliance and they understand the hazards involved. Children must not play with the appliance. Unsupervised
children must not perform cleaning and maintenance tasks.
- If the power cable is damaged, it must be replaced by the manufacturer, after-sales service provider or similarly qualified
personnel in order to prevent any hazards.
- Do not attempt to alter the control unit to run at a different voltage.
- Be sure to make secure electrical connections to avoid contact failures, as these may cause overheating.
- Before installing or replacing any system component, make sure that it has been disconnected from the power supply and
that there is no water flowing through it. Only use original replacement parts.
- Because the device generates heat, it is important to install it in a sufficiently ventilated place. Do not install it near flammable
materials.
- Although the device has an IP code, under no circumstances should it be installed in areas exposed to flooding.
- This device is intended to be permanently connected to a water supply and must not be connected with a temporary hose.
- This appliance is equipped with a mounting bracket. See assembly instructions.
130
EN