VEVOR RC-9002F Originalanleitung Seite 21

Release the plug from the clog
When the dredging head is stuck in the blockage, set CW /OFF/ CCW to
OFF , release the foot switch, and use your hands as much as possible to
open the blockage.
Pull the cable out of the obstruction. If it cannot be pulled out, set CW
/OFF/ CCW to CCW position, hold the cable with both hands,
Press the foot switch and turn it for a few seconds to withdraw the cable.
Do not continue to use CCW after withdrawing the dredging head .
This will damage the cable. Put the gear in CW and continue working.
Recycling Cable
Once the pipe is completely cleared, you can use water to flush out the
blockage, but pay attention to changes in water flow, as it may
This will cause the pipe to become clogged again.
As the water flows through the pipe, the cable can be retrieved. CW / OFF /
CCW is set to CW and does not reverse.
Lower the reel cable. Use both hands to reel the cable into the drum. Each
reel cable should be approximately 6-12 inches long. Rinse
The water flow in the pipe can also clean the wire rope. Continue to retract
the wire rope, and when the dredge head is about to come out, release the
foot pedal.
Do not rotate the machine and remove the dredge head directly from the
pipe, as this will cause
Whiplash injury.
the switch to OFF , unplug the cable, pull the remaining cable out of the
pipe and put it into the drum.
If necessary, replace the dredging head and continue other work. It takes
several times to dredge the pipe completely.
pipeline.
- 20 -