Machine Inspection - Vevor Rc-9002F Originalanleitung

Machine inspection

Before using the machine each time, please check the machine according
to the following steps to avoid unnecessary accidents, such as electrical
Hit, cable twisted, broken, etc.
Always wear safety glasses, drain cleaner gloves, and other appropriate
protective gear, such as chemical protection, liquid-resistant gloves worn
over drain cleaner gloves, etc.
1. Check the gloves used for the dredging machine to make sure there are
no damage, wear and loose parts, otherwise these parts can easily get
caught in the wire rope and cause danger. Gloves can protect your hands
from being injured by the rotating wire rope. If the gloves are damaged,
worn or have loose parts, please replace them with new gloves before
using the dredging machine.
2. Check the power cord, leakage protector and plug. If the plug is
damaged, deformed or missing the grounding head, or the wire is
damaged, please replace it immediately and stop using the machine.
3. Clean the oil, grease and dust on the handle and control parts, which
can reduce the occurrence of various hazards and facilitate control.
machine.
4. Make sure there is a foot switch and it is correctly connected to the
machine. Do not use the machine without the foot switch.
5. Check if the machine is assembled correctly. Check if any moving parts
are in the wrong position, or if any parts are damaged or other
If there is any damage that may affect the normal use of the tool, please
make sure to repair it before use.
- 10 -