VEVOR RC-9002F Originalanleitung Seite 20

If the water is bent or blocked, do not let the cable grow longer outside the
pipe, as this will cause knots, twists, or even
To break.
Pay attention to the length of the cable entering the cable, the cable enters
the larger sewer pipe or switches to enter the smaller pipe size,
It is easy to cause the wire rope to get tangled and prevent the wire rope
from running out of the pipeline. Try to minimize the risk of the wire rope
passing through pipelines of different sizes.
The problem arises.
Clear the blockage
If the dredging head is inserted into the blockage and cannot rotate, the
cable will be twisted because the machine is still running, and
It is getting more and more serious. You need to pull back the cable to
make the dredging head withdraw and release the stress of the cable.
Stop the dredging head from rotating while still running the machine to
cause the cable to twist.
If the blockage is cleared, return the dredging head and let it rotate in the
blockage to continuously break up the blockage until it is cleared.
The head can be bent and rotated freely.
After the blockage is cleared, the steel cable and the dredging head may
be filled with dirt, affecting the normal work. In this case, the steel cable
and the dredging head need to be returned.
Clean up this garbage.
Dealing with the dredge in the clog
If the dredging head enters the blockage and cannot rotate or withdraw,
release the foot switch and hold the steel
Otherwise the cable will get tangled, twisted and broken. The motor stops
and the drum rotates to release the tension in the cable.
Release the tension in the cable until all tension is released, then release
your hands. Set the switch CW /OFF/ CCW to the OFF position.
- 19 -