HOMCOM FDP20-2024R5 Bedienungsanleitung Seite 9

EN
·
operation:
1.The operation is effective when the unit is under
2. Press the
up centrifugal fan will turn to low speed automatically. The set temperature will
increase 1℃ after one hour, and increase 2℃ after two hours. After six hours, the unit
will stop running.
Notice :
The main control board has memory function, when the unit is ready to run but in stop
status, the main control board can memorize the initialization of working mode. When
you tun on the unit it will work as the same enactment of working-mode as last time, no
need to reset the working mode again. (This condition is not available when the unit is
under " " mode)
REMOTE CONTROLLER
Remote controller
The remote controller transmits signals to the system.
1. BUTTON
The appliance will be started when it is energized or
will be stopped when it is in operation, if you press
this button.
2. BUTTON
Press this button to select the operation mode.
3. BUTTON
Used to select fan speed in sequence
4.5 and
Used to adjust the room temperature and the timer.
6. BUTTON
Used to set or cancel
7. BUTTON
Used to set automatic off and automatic on time.
button in mode, then the unit will work under sleep mode and the
SETTING BUTTONS
Mode operation.
mode.
or .
8