HOMCOM FDP20-2024R5 Bedienungsanleitung Seite 8

EN
4. Adjust Fan Speed
Press the " " button to select a desired fan speed shown below:
5.Power
When you press "
NOTICE
Each mode working principle
· mode:
1.Once the
automatically to select the desired operation mode with
2.When the room temperature >24℃,the unit will automatically select
3.When the room temperature < 24℃,the unit will automatically select
·
mode:
1. The up centrifugal fan will run at low speed ,and the speed can't be adjusted.
2. The compressor and the down centrifugal fan will stop after running 8 mins, then run
again after 6 mins.
3. The unit adopts constant temperature dehumidifying mode, and the adjustment of
temperature is no effective.
·
mode:
1. When the room temperature is higher than set temperature ,the compressor starts to
run.
2. When the room temperature is lower than set temperature ,the compressor stop and
upper fan operate at original set speed.
·
mode:
1.The fan runs at set speed, and the compressor does not run.
2.The adjustment of temperature is negative.
·
operation:
1.Press "Timer" button to set Automatic Off time while the unit is running.
2.Press "Timer" button to set Automatic On time while the unit is ready.
3.The time can be adjusted within a range of 1 hour to 24 hour. Press the temp up (
or temp down (
" button again ,the unit will emit "di" and stop working.
Operation is selected, the indoor temperature sensor operates
) button to increase or decrease the time 1 hour by pressing once.
or
7
.
mode.
mode.
)