EN
How to install batteries
·Inserting batteries
1. Open the back cover, and take off the isolating film on the batteries;
2. Put the batteries inside the slot, with anode and cathode in right directions;
3. Put on the back cover.
Notices:
1) The anode and cathode of the batteries must be corresponding to the signs of "+"
and "-"on the remote control;
2) Do not use new battery cells together with run-down cells;
3) For long time no use, take out the batteries;
4) To prevent environmental pollution, take out the used batteries and dispose safely
and appropriately.
• INGESTION HAZARD: This product contains a button cell or coin battery.
• DEATH or serious injury can occur if ingested.
• A swallowed button cell or coin battery can cause Internal Chemical
Burns in as little as 2 hours.
• KEEP new and used batteries OUT OF REACH Of CHILDREN
• Seek immediate medical attention if a battery is suspected to be
swallowed or inserted inside any part of the body.
Battery
1)Battery type:CR2025
2)Nominal Voltage: 3V
Instructions and manuals
a) Remove and immediately recycle or dispose of used batteries according to local
regulations and keep away from children. Do NOT dispose of batteries in
household trash or incinerate.
b) Even used batteries may cause severe injury or death.
c) Call a local poison control center for treatment information.
d) Non-rechargeable batteries are not to be recharged.
Slide the cover to open.
Be sure the direction is correct
WARINING
9