HOMCOM FDP20-2024R5 Bedienungsanleitung Seite 13

EN
Maintenance after using
1. lf the appliance will not be used for a long time, be sure to Pull out the primary and the
secondary rubber plug of the drain port , in order to drain the water.
2. Keep the appliance running with fan only for a half day during a sunny day to dry the
appliance inside and prevent from going mouldy.
3. Stop the appliance and pull out the power supply plug, then take out the batteries of
remote controller and store appliance properly.
4. Clean the air filter and reinstall it.
5. Remove the air hoses and store them properly, and cover the hole tightly.
TROUBLESHOOTING
The following cases may not always be a malfunction, please check suggestions
below before asking for service.
Does not run.
Runs for a short while only.
Runs but not cooling
Water leak during moving
Trouble
Don't
cool
Analysis
• If the protector trip or fuse is blown.
• Please wait for 3 minutes and start
again, protector device may be
preventing unit from working.
• If batteries in the remote controller are
exhausted.
• If the plug is not properly plugged in.
• If the set temperature is close to room
temperature, you can lower the set
temperature.
• Air outlet is blocked by obstacle. Take
the obstacle away,
• If the door or window is open.
• If there is another appliance heat-
working, like heater or lamp, etc..
• The air filter is dirty, please clean it.
• Air outlet or intake is blocked.
• Set temperature is too high.
• Drain the condensate before moving.
• To avoid water leakage, please locate
the unit on flat ground..
12