Activating And Deactivating Bluetooth® Radio Interface; Assembling The Trimmer; Mounting The Loop Handle - Stihl Fsa 86 R Gebrauchsanleitung

English
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue for approximately 3 seconds.
®
The Bluetooth radio interface on the battery
is activated.
7.2
Deactivating the Bluetooth
Radio Interface
► If the battery has a Bluetooth
Press and hold the pushbutton until the
®
"BLUETOOTH " LED next to the
lights up blue six times.
®
The Bluetooth radio interface on the battery
is deactivated.
7.3 Reset battery to the factory set‐
ting via a Bluetooth
face (AP 200.0 S, 300 S,
300.0 S, 500.0 S only)
Resetting the battery to the factory setting means
that all user-specific data will be deleted.
► Press the pushbutton four (4) times in quick
succession and keep it pressed on the fourth
time until the "BLUETOOTH
the symbol flashes blue.
► Then release the pushbutton immediately.
► Connect the battery to the STIHL connected
app and check whether all user-specific data
has been deleted.
8

Assembling the Trimmer

8.1 Mounting the bump guard
► Switch off the brushcutter and remove the bat‐
tery.
28
Radio
®
®
radio interface:
symbol
®
®
radio interface:
symbol
radio inter‐
®
®
" LED next to
2
2
1
7 Activating and Deactivating Bluetooth® Radio Interface
► Insert the ends of the bump guard (1) into the
holes (2) in the housing.
The bump guard (1) need not be removed.
8.2 Mounting the guard
► Switch off the brushcutter and remove the bat‐
tery.
1
2
The line limiting blade (1) has already been
installed in the guard (2) and must not be
removed.
► Push the guard (2) into the guides on the
housing until it hits the limit stop.
The guard (2) is flush with the housing.
► Insert and tighten down the screws (3).
The guard (2) must not be removed.
8.3

Mounting the Loop Handle

► Switch off the brushcutter and remove the bat‐
tery.
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Fit and tighten down the nuts (7) firmly.
2
1
2
3
4
5
6
7
0458-833-9621-D
3